Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
Using the Dremel tool, drill a hole through the top of the truck. Moisten a sponge and wipe bisque to remove any dust.
Using the Script Liner and Detail Liner with SC-74 Hot Tamale, apply two coats to the body of the truck. Allow glaze to dry between coats.
Using the Detail Liner with SC-6 Sunkissed, apply two coats to the lights. Allow glaze to dry between coats.
Using the Detail Liner with SC-60 Silver Lining, apply two coats to the bumpers and hubcaps. Allow glaze to dry between coats.
Using the Script Liner and Detail Liner with SC-15 Tuxedo, apply two coats to the tires. Allow glaze to dry between coats.
Using the Detail Liner with SC-15 Tuxedo, apply accent lines to the truck.
Fire to cone 06.
After the truck is cool, cut a 14″ piece off of the twine. Fold it in half. Take the wire and cut a 5″ piece. Run the wire through the looped end of the twine and fold in half. Take the wire and pull it through the hole in the truck from the bottom up. Pull the twine through until the loop is big enough to hang on a tree. Tie a knot at the hood of the truck. Tie a large knot at the bottom of the truck. Cut off any excess.
Use the hot glue gun to glue presents in the bed of the truck.
