Non Toxic, Non Fired Products - Water Based
North American Format
SECTION 1: COMPANY & PRODUCT IDENTIFICATION
|Prepared:||November 4, 2010|
|Supersedes:||August 1, 2010|
|Manufacturer:||Coloramics, LLC (D.B.A. Mayco Colors)|
|4077 Weaver Court South|
|Hilliard, Ohio 43026|
|United States of America|
IN CASE OF EMERGENCY PLEASE CONTACT YOUR REGIONAL POISON CONTROL CENTER
Product Identification: Acrylic Paints & Stains
Product Usage: Decoration of ceramic & craft surfaces
Product Lines Covered by this Safety Data Sheet:
|Softees® Acrylics Stains||SS-2 through SS-399|
|Softees® Pearls||SS-112 through SS-417|
|Dazzling Metallics®||SS-80 through SS-459|
|Sparkling Sandstones||CSS-3 through CSS-49|
|Magic Metallics||MM-100 through MM-106
MM-200 through MM-305
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
|Ingredients||CAS||% of Formula
(Low to High)
|Silica (Quartz)||14808-60-7||1% - 3%|
|Calcium Carbonate||471-34-1||0% - 3%|
|Titanium Dioxide||13463-67-7||0% - 20%|
|Kaolin/Clay||1332-58-7||2% - 7%|
|Texanol||25266-74-4||0.1% - 23%|
|Hydroxyethyl Cellulose||9004-62-0||0% - 2%|
|Vinyl Acrylic Latex||Unknown||0% - 20%|
|Propylene Glycol||57-55-6||2% - 7%|
SECTION 3: HAZARDS IDENTIFICATION
Crystalline silica dust may be present if dried products are excessively handled and allowed to create dust.
Mists from spraying may contain crystalline silica.
Route(s) of Entry: Inhalation, Ingestion; absorption through the skin is negligible.
SECTION 4: FIRST AID MEASURES
- If inhaled: May cause irritation; remove from exposure
- If on skin: May cause irritation; wash skin with soap and water
- If in eyes: May cause irritation; flush eyes with large quantities of water for at least 15 minutes. If irritation persists after washing, contact a physician.
- If swallowed: Contact a physician.
SECTION 5: FIRE FIGHTING MEASURES
|Suitable Extinguishing Media||None|
|Special Hazards Arising From Chemical Fire||None|
|Special Protective Equipment and Precautions for Fire Fighters:||None|
SECTION 6: ACCIDENTAL RELEASE MEASURES
Steps to be taken in case material is released or spilled:
Personal Precautions, Protective Equipment and/or Emergency Procedures: None
Materials and Methods for Containment and Clean-Up: None
SECTION 7: HANDLING AND STORAGE
PRECAUTIONS FOR SAFE HANDLING AND USE:
- Ventilation: Local exhaust (if spray applying)
- Precautions for Safe Handling: None
- Conditions for Safe Storage, Including Incompatibilities: None
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
|Silica (Si O2)||30 mg/m3||0.025mg/m3|
|Calcium Carbonate||15 mg/m3||N/A|
|Vinyl Acrylic Latex||N/A||N/A|
- Engineer Control: Adequate ventilation (local exhaust) if spray applied.
- Respiratory Protection: Use a NIOSH approved respirator if spray applying.
- Protective Gloves: Not normally needed.
- Eye Protection: Wear appropiate eye protection or safety glasses to keep dust out of eyes.
- Other Protective Clothing or Equipment: Wear appropriate clean, protective clothing such as, but not limited to, overalls, smocks, and aprons.
- Work/Hygienic Practices: Food, beverages, and smoking materials should not be in the work area. Hygiene is very important. Wash thoroughly before eating, drinking, smoking, or applying cosmetics.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
|Appearance:||Colored and/or Clear Liquids|
|Upper/Lower Explosive Limits:||None|
|Partition Coefficient (n-octanol/water):||None|
|Auto ignition temperature:||N/A|
SECTION 10: STABILITY AND REACTIVITY
|Possibility of Hazardous Reactions:||None|
|Conditions to Avoid:||Mist created from spray application.|
|Hazardous Decomposition or By-Products:||N/A|
SECTION 11: TOXICOLOGY INFORMATION
Primary Route(s) of Entry: Dermal, Inhalation. The highest threat of inhalation exists during dispensing and mixing of dry products, excessive handling of dried, unfired glazed ware and/or during spray application.
Symptoms related to physical, chemical and toxicological characteristics: May cause mechanical irritation.
These mixtures contain silica, a know carcinogen. Inhalation is the only route of entry into the body that can cause Silicosis.
These water-based, premixed products should be non-toxic during recommended use.
Pigments are both organic chemicals and various metals and metal compounds (may contain one or more of following: iron, zinc, copper, aluminum, titanium, barium, manganese). Pigments may also contain ethylene glycol, diethyl glycol, talc, carbon black and other solvents.
The risk of exposure to these pigments is minimal due to the low percentage used in the formulas. Dermal exposure is negligible as these metals have poor dermal absorption.
Carbon Black is considered animal carcinogen. Silica (quartz) is considered a human carcinogen.
These products conform to ASTM-4236 and have been certified by an independent, 3rd party toxicologist to be NON TOXIC.
SECTION 12: ECOLOGICAL INFORMATION
|Mobility in Soil:||No|
|Other Adverse Effects:||None|
SECTION 13: DISPOSAL CONSIDERATIONS
Waste Residue/Disposal Methods: None
Safe Handling Information: None
SECTION 14: TRANSPORTATION INFORMATION
UN Shipping Name: N/A
UN Number: None
Environmental Hazard: None
Packing Group: None
Transportation Hazard Class: N/A
Special Precautions: None
SECTION 15: REGULATORY INFORMATION
Silica (Quartz), and Carbon Black are listed by California, Proposition 65, as carcinogenic.
Silica (Quartz), and Carbon Black are listed on the IARC, OSHA or NTP carcinogen list.
All ingredients are on U.S. TSCA Inventory.
SARA Section 313: None
These products conform to ASTM-4236. Materials have been evaluated under the provisions of LHAMA (Labeling of Hazardous Art Material Act). Products listed on this SDS have been judged to be non-toxic and non-flammable under proposed use conditions. No special warning is required under provisions of LHAMA or California Proposition 65.
SECTION 16: ADDITIONAL INFORMATION
Mayco Glazes do not contain and products and/or ingredients derived from peanuts, eggs, milk, or wheat.
This information is furnished with out warranty, representation, inducement or license of any kind, except that it is accurate to the best of knowledge of COLORAMICS, LLC or obtained from sources believed to be accurate.
COLORAMICS, LLC does not assume any legal responsibility for use or reliance on same. Customers are encouraged to conduct their own tests before using any product. Read the product label.