Can-It Redneck Wine Cooler

redneck wine cooler

Products Used

  • MB-1401 Can-It Gallon
  • SC-3 Wine About It
  • SC-13 Grapel
  • SC-34 Down To Earth
  • SC-26 Green Thumb
  • SC-63 Popeye's Favorite
  • FN-038 Wisteria Purple
  • SS-81 Shimmering Silver
  • S-2000 Crystal Clear Dipping
  • SC-15 Tuxedo
  • SG-401 Designer Liner Black

Decorating Accessories

  • CB-110 #10 Script Liner
  • BT-910 Synthetic Sponge
  • CB-106 #6 Script Liner
  • CB-604 Soft Fan
  • AC-230 Clay Carbon Papper

Additional Materials


Designer: Marcia Roullard
Download Project (pdf): Redneck Cooler


  1. Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
  2. Thin FN-038 Wisteria Purple with water, 3:1 (glaze to water)
  3. Pour the thinned FN-038 Wisteria Purple inside MB-1401 Can It-Gallon bisque and rotate to cover the interior. Drain excess glaze.
  4. With AC-230 Clay Carbon Paper, trace the pattern on to MB-1401 Can-It Gallon bisque.
  5. Using CB-106 #6 Script Liner, brushing in a circular motion, apply SC-3 Wine About It and SC-13 Grapel to the grapes. Allow glaze to dry completely between coats. Apply two coats.
  6. Using CB-106 #6 Script Liner, apply SC-26 Green Thumb to the leaves and brush SC-63 Popeye's Favorite or the edges.
  7. Using CB-110 #10 Script Liner, apply SC-34 Down To Earth to the grapevines.
  8. Using CB-110 #10 Script Liner, outline the traced pattern with SC-15 Tuxedo.
  9. Using CB-106 #6 Script Liner, apply SC-34 Down To Earth in a flat stroke motion to shade under the rims of the MB-1401 Can It-Gallon.
  10. With SG-401 Black, write "Vino" on the MB-1401 Can It-Gallon.
  11. Using CB-604 Soft Fan, apply SC-15 Tuxedo is to the rims and bottom of the the MB-1401 Can It-Gallon.
  12. Dip MB-1401 Can It-Gallon in S-2000 Crystal Clear Dipping. Drain excess and allow to dry completely.
  13. Fire to cone 05/06.
  14. Using CB-604 Soft Fan, apply SS-81 Shimmering Silver to the top and bottom rims of the MB-1401 Can It-Gallon to give a metallic look. Brush over the SS-81 Shimmering Silver, gently, with water to allow the glaze to show through.
  15. Using Wire Cutters, cut a coat hanger and bend over a circular shape (one that is smaller in diameter than the bisque can). Bend the ends to fit through the holes on each side.
  16. Using CB-604 Soft Fan, lightly brush SS-81 Shimmering Silver over the coat hanger.

Who We Are

Our purpose, history, and policies

About Us

Site Map

Warranty & Freeze Policy

Where To Buy

Find the best place to purchase Mayco products

Dealers & Retailers


PYOP & Ceramic Studios 

Contact Us

 (614) 876-1171 |   (614) 876-9904

Technical Support