Power Flower




Products Used

  • MB-102 - Coupe Dinner Plate 9¾"
  • MM-105 - Gold Metallic
  • MM-202 - Green Patina
  • SS-138 - Flat Black
Decorating Accessories
  • AB-834 - ¾" Acrylic Base Coat
  • AC-213 - Sponge on a Stick - 1¼"Diameter
  • BT-910 - Synthetic Sponges
MB102 MM Flowers
Additional Materials
  • Foam Flower Stamp
  • Large Spiral Foam Stamp
  • Flat Black Spray Paint
  • Paper Towel
  • Foam Plates
Project Info




  1. Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
  2. Spray paint the plate with a Flat Black Spray Paint. Allow to dry.
  3. Shake and stir MM-105 Gold Metallic well. Place some an a foam plate.
  4. Using a CB-834 ¾" Base Coat brush, apply 1 coat of MM-105 Gold Metallic to the top of the plate. Allow to dry. Apply a second coat of Gold Metallic paint.
  5. Stamp the center area of the plate with the large spiral stamp covered with SS-138 Flat Black. To avoice overloading the stamp with paint, use a Sponge on a Stick to pat the stamp with the acrylic first. Then apply the stamp to the plate.
  6. Spray the edge area of the plate with the black spray paint. This will put a light mist of black over the center area of gold.
  7. Use small flower stamps to stamp on MM-105 Gold Metallic on the border of the plate.
  8. Protect the center of the plate with paper towel, so as to not get the green patina spray in the center. Spray the gold flowers with MM-202 Green Patina before they dry.