- Last Updated: Tuesday, 17 September 2019 16:37
- MB-1503 Saguaro Cactus Vase
- FN-001 White
- CG-753 Sassy Orange
- CG-756 Firecracker
- CG-954 Wildfire
- CG-968 Peppermint Twist
- S-2723 Grape Divine
- SC-6 Sunkissed
- SC-23 Jack O’ Lantern
- SC-26 Green Thumb
- SC-74 Hot Tamale
- SC-97 Cant-elope
- SG-401 Black
- SG-405 Green
- SG-407 Yellow
- SG-408 Orange
- SG-411 Purple
- AC-230 Clay Carbon Paper
- RB-144 #4 Soft Fan
- RB-106 #6 Script Liner
- RB-110 10/0 Detail Liner
- ST-103 Retro Star Stamp
Sponge, Water, Sponge on a stick, Palette, Pencil
Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
Using the Soft Fan with FN-001 White, apply 3 coats to the front and sides of the canvas. Allow glaze to dry between coats.
Squeeze 1 TBS of SC-97 Cant-elope, SC-23 Jack O’ Lantern, and SC-6 Sunkissed onto the palette. Take the ST-103 Retro Star Stamp and place it design-side up. Take the sponge on a stick and gently dab it into the glazes. Use the 3 colors to cover the stamp. Gently press the stamp onto the front of the canvas. Repeat until the front is covered.
Place the AC-230 Clay Carbon Paper over the front of the canvas. Place the pattern over the paper and trace with the pencil.
Using the Script Liner with CG-756 Firecracker, apply 1 puddle coat to the body of the bird and the center of the lower-left flower.
Using the Script Liner with CG-753 Sassy Orange, apply 1 puddle coat to the wing of the bird and the center of the upper right flower.
Using the Script Liner with CG-968 Peppermint Twist, apply 1 puddle coat to the 3 small circle flowers.
Using the Script liner with CG-954 Wildfire, apply 1 puddle coat to the remaining upper flower.
Using the Script Liner with S-2723 Grape Divine, apply 1 puddle coat to the remaining lower flower.
Using the Script Liner with SC-26 Green Thumb, apply 1 coat to the stems and leaves.
Using the Script Liner with SC-6 Sunkissed and SC-74 Hot Tamale, apply 2 coats to the outer parts of the corresponding flowers.
Using the Detail Liner with SC-23 Jack O’ Lantern, apply 2 coats to the beak. Allow glaze to dry between coats.
Using SG-401 Black, SG-405 Green, SG-407 Yellow, SG-408 Orange and SG-411 Purple, outline the corresponding parts of the flowers, leaves and bird.
Fire to cone 06.