Tulip Plate

 

 
 
Products Used

Bisque
  • MB-101 - Coupe Salad Plate
Color
  • FN-001 White
  • FN-003 Orange
  • FN-004 Red
  • FN-007 Green
  • FN-009 Black
  • FN-010 Tree Green
  • FN-017 Purple
  • FN-037 Chartreuse
Decorating Accessories
  • CB-110 #10/0 Liner
  • CB-106 #6 Script Liner
  • CB-604 #4 Soft Fan
  • BT-910 Synthetic Sponge
pt_2012_tulip_plate
 
 
Additional Materials
  • Pencil
  • Scissors
  • Paper Towel
  • Download Project Pattern: Tulip
 
Project Info
  • Designer: Marcia Roullard
  • Skill Level: Intermediate
  • Time: 1½ hours
 

Instructions

  1. Begin with properly fired shelf cone 04 bisque.  Moisten a clean sponge and wipe bisque to remove any dust.
  2. Using a CB-604 #4 Soft Fan, apply 2 coats of FN-037 Chartreuse to the top of the plate. Allow to dry.
  3. Cut out the tulips with the stems and leaves. Pencil in the placement of the flowers on the plate.
  4. Using a CB-106 #6 Script Liner, apply 2 coats of FN-004 Red to the flower head, fading to FN-003 Orange towards the top directly onto the piece.
  5. Using a CB-106 #6 Script Line, apply FN-010 Tree Green to the stems and leaves, highlighting with FN-007 Green.
  6. Place the cut out flower form over the proper flower, brush some water under the paper cut out flower then press down with paper towel to get the paper to stick.  This will act as a mask so that the background can be painted.
  7. Using a CB-604 #4 Soft Fan, brush over the edges of the paper with more of the FN-037 Chartreuse, so that it will cover any color from the flowers and leaves that could be peeking through at the edges of the paper.
  8. Using a CB-604 #4 Soft Fan, dry brush FN-017 Purple over areas to the sides of the tulips to shade, brushing in an upward direction. Add FN-037 Chartreuse to the brush with a little of FN-001 White to lighten the background near the top of the plate. Apply 2 coats.
  9. For the lower area of the plate, Using a CB-604 #4 Soft Fan and a CB-106 #6 Script Liner, apply FN-010 Tree Green, with a dry brush stoke apply the color in an upward direction.  Add some FN-009 Black to FN-010 Tree Green to deepen the green and repeat with a dry brush stroke. Pull up brush to end strokes so to resemble blades of grass.
  10. Remove the all the paper cutouts before the last coat of glaze dries to avoid chipping.
  11. Using a CB-604 #4 Soft Fan, apply 2-3 coats of FN-009 Black to the back of the plate. Allow to dry.
  12. Stilt and fire to shelf cone 06.

Who We Are

Our purpose, history, and policies

About Us

Site Map

Warranty & Freeze Policy

Where To Buy

Find the best place to purchase Mayco products

Dealers & Retailers

Distributors

PYOP & Ceramic Studios 

Contact Us

 (614) 876-1171 |   (614) 876-9904

info@maycocolors.com

Technical Support

614-675-2031

technical@maycocolors.com