Molten Stoneware



Stroke & Coat, Stoneware Glazes and wax resist combine for a "hot" look.

Products Used

  • CD-1127 - Round Pot
  • SC-87 Ruby Slippers
  • SW-104 Black Walnut
Decorating Accessories
  • AC-302 Wax Resist
  • BT-910 Synthetic Sponges
  • CB-406 #6 Pointed Round
  • CB-604 #4 Soft Fan
  • AC-525 Brush Cleaner
Additional Materials
  • Stoneware Casting Slip
Project Info




  1. Cast the CD-1127 Round Pot with Stoneware casting slip.
  2. Remove the ware from the mold. Allow to dry.
  3. Clean the stoneware greeware by carfully removing the seamlines using a clean-up tool.
  4. Bisque fire the piece to shelf cone 04.
  5. Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
  6. Using a CB-604 #4 Soft Fan, apply 2 coats of SC-87 Ruby Slippers on the outside of the pot.
  7. Condition a CB-406 #6 pointed Round by dampening the brush in water and squeezing out any excess water. Load the brush with AC-525 Brush Cleaner then squeeze between a paper towel.
  8. Apply a good coat of AC-302 Wax Resist on the desired areas (in this case, the red "oval" areas). Allow to dry.
  9. Dip the entire piece into SD-104 Black Walnut. Do 2 dipped coats. Allow to dry in between each coat).
  10. With a damp sponge clean the glaze off the bottom of the piece, (dry-foot).
  11. Fire to shelf cone 6 (mid-range).

Who We Are

Our purpose, history, and policies

About Us

Site Map

Warranty & Freeze Policy

Where To Buy

Find the best place to purchase Mayco products

Dealers & Retailers


PYOP & Ceramic Studios 

Contact Us

 (614) 876-1171 |   (614) 876-9904

Technical Support